This is however an easy job and should take you between 30 minutes and 1 hour. Removing and replacing toilet tank bolts means that you will also be removing the toilet tank and then installing it later. If on the other hand they are still leaking or you just want a long term fix, you need to replace them. If the toilet tank bolts have stopped leaking then you are home and dry.
If you live in area with hard water you are more likely to experience this problem than people with soft water. If however the bolts are old and corroded or if the washers are worn out, replace the bolts, washers and tank to bowl gasket. To fix leaking toilet tank bolts, start by trying to tighten them especially if the tank is wobbling. With time, the toilet tank bolts become loose, corroded or the rubber washers are worn out resulting in a leaking toilet tank. To avoid leaking, rubber washers are normally installed together with the bolts from the inside of the tank. Once in place and secure, tighten the bolts and reattach the water connections before turning the water supply back on and testing your toilet repair.If you ever notice water pooling around the base of your toilet, most likely it is as a result of a leaking wax ring, but it could also be that your toilet is leaking from the tank bolts.Ī toilet tank is joined to the bowl using 2 or sometimes 3 bolts. With the new flange and bolts in place you can put the toilet back on, being careful to line up the holes in the bottom with the bolts on the floor. The flange serves as a place to put the Johnny bolts in, in order to secure the toilet. Remove the flange where the toilet was and replace it with a new one. Step 5 - Replace the Floor Flange and Johnny Bolts The wax bowl ring will be worn and it will take some time to completely scrape it a way from the toilet. Using a putty knife you need to scrape away the old wax bowl ring or gasket and clean the underside in order to replace it with a new one. Place the toilet in a spot away from the bathroom if possible where it can be turned upright in order to gain access to the bottom. This is best done with assistance in order to avoid injury.
#How do i remove toilet tank bolts that are stuck free#
With the toilet bolts removed you should be able to lift it free and away from the floor. You also need to disconnect the water pipe that is attached to the toilet in order to remove it from the floor. If the threads of the bolts are stripped and you are unable to remove them, use a hack saw to cut the bolts loose. More than likely however you will need to apply some 3-in-1 oil or liquid wrench to loosen the bolts holding the toilet in place. If you are lucky the toilet tank bolts will be somewhat intact and you will be able to remove them easily with a monkey wrench. Flush the toilet to drain the tank in order to get it ready to be removed. Use a toilet brush and cleaner to clean the inside of the bowl. This will shutoff the water coming into the toilet. Turn the valve that controls the water near the bottom of the toilet counter clockwise until it is tight. Place large towels around the toilet to soak up any water that will inevitably end up on the floor. Step 2 - Clean the Toilet and Drain the Tankīefore you begin the process of replacing the toilet tank bolts you will need to clean and drain the toilet in order to remove it.
0 kommentar(er)
